Eltek Delta OP - DELTA OP Connectivity; Communication Ports Details

2 Brief Description of DELTA OP
10 User’s Guide '(/7$23
&RPPXQLFDWLRQV3RUWV
The '(/7$23 panel has 3 communications ports for integrating the panel
with other network equipment. The communications ports support several
protocols, which can be selected by configuring the panel or by using plug-in
circuit cards.
&20DQG&20
The COM1 and COM2 communications ports — see Figure 2 — are 9-pin D-
Sub male ports principally intended for communication with computers,
printers, modems and other external units by using the standard 563RLQWWR
3RLQWserial bus.
The COM1 and COM2 ports can also be configured to support the ‘56
0DVWHU6ODYH¶ serial bus for communications with other network equipment on
the RS485 bus.
'(/7$1HW&RPPXQLFDWLRQV3RUW²H%XV
The '(/7$1HW communications port is based on the use of ".LWIRU23'$
H%XV&RPPXQLFDWLRQ%RDUG" — a circuit card to be plugged on the '(/7$23
main card.
.LWIRU23'$H%XV&RPPXQLFDWLRQ%RDUG
Terminal block connections CN1-7.8 on '(/7$23 are to be used for
communications via a IUHHWRSRORJ\PXOWLPDVWHUH%XVfor connecting to other
modules and fire alarm systems in the '(/7$ and ANX95 families.
'(/7$23 must then use the plug-in ".LW IRU23 '$ H%XV&RPPXQLFDWLRQ
%RDUG"
You can find more information in the folder, ‘Installation Guide for .LWIRU23
'$H%XV&RPPXQLFDWLRQ%RDUG, which accompanies kit.
Figure 2 Communication ports on the '(/7$23 panel
'(/7$

23
RS232
COM1
RS232
COM2
CN1
8,7
eBus
eBus Multi-master Bus
&RPPXQLFDWLRQVSRUWV&20DQG
&20
used as:
◊
3RLQWWR3RLQW566HULDO%XV
 or
◊ 0DVWHU6ODYH566HULDO%XV
'(/7$

1HW
FRPPXQLFDWLRQSRUW²H%XV
◊ H%XV 0XOWLPDVWHU , free-topology Bus
RS232 Serial Bus
or
RS485 Master / Slave Serial Bus
R
U