Eltek Delta OP - Graphic Display; How to Silence the Buzzer & Alarm Bells; How to Reset the Operating Panel; M-Key Doesn’t Work When the System Is in Alarm Mode, Why?

1 Welcome
User’s Guide '(/7$23 3
4XLFN5HIHUHQFH*XLGHFXWRXW
Front Keys and LED ’s in '(/7$23
1
1. )XQFWLRQNH\V
(9$&8$7(6&52//',63/$<DQG087(%8==(5
11. )$8/7
2. 7(67 12. 6<67(0)$8/7
3. 32:(5 13. '\QDPLFµ6RIW¶.H\V
4. — 14. *UDSKLFGLVSOD\

5. $/$5075$160,77(' 15. 08/7,3/($/$506
6. ² 16. 6,/(1&($/$50
7. ² 17. 5(6(7
8. $/$50 18. 2SHUDWLQJSDQHO¶V.H\6ZLWFK
9. ,62/$7,21 19. 1XPHULFNH\SDG
10. 35($/$50 0 to 9 ,  and M
3
1
Find more information about "Front Keys and LED’s" on page 14.
2
Find more information about "Graphic Display" on page 13.
3
Note that the graphic symbols represent actions – the symbols do not appear on the panel. F= press key
How to reset the
Operating Panel
To reset the fire alarm system
to its QRUPDOPRGH of
operation:
B 8QORFNWKHSDQHO
with the key switch
F 5(6(7
— for at least 2 seconds (more
information on page 15)
The M–key doesn’t work when the
system is in alarm mode Why?
When the fire alarm system reports an
alarm — pre-alarm, fire or fault alarm —
you have to unlock the panel BEFORE
using the menus.
Do as follows:
B 8QORFNWKHSDQHO
with the key switch
F M (PDLQPHQX)
You have now access to the PDLQPHQX
(Find more information on "The Operating
Menus" on page 22.
How to silence the
buzzer & alarm bells
To silence the internal
buzzer and the alarm bells
— after a fire or fault
alarm has been reported
— press following keys:
B
 8QORFNWKHSDQHO
with the key switch
F 6,/(1&($/$50
— press this key again to
reactivate the alarm
8
7
6
5
4
3
2
9
10
11
12
1
13
14
16
17
19
18
15