Eltek Delta OP - Page 4

1 Welcome
4 User’s Guide '(/7$23
4XLFNUHIHUHQFHJXLGHFXWRXW
+RZWRUHVHWDODUPV
When the operating panel system reports an alarm
— pre-alarm, fault or fire alarm — you must press
the following keys:
$ /RFDWHDQGUHPRYHWKHFDXVHRIWKH
DODUP
and when the situation is under control
B 8QORFNWKHSDQHO
with the key switch
F 5(6(7
— for at least 2 seconds
More information on pages 16, 17 and 18.
+RZWRLVRODWHDGHWHFWRU
If you want to disconnect an addressable detector
— for example detector ‘0245’ — you must press
the following keys on the numeric keypad:
B 8QORFNWKHSDQHO
with the key
F M (main menu)
F ó (ISOLATE / DE-ISOLATE)
F ó (ISOLATION)
F  (PERMANENT)
F ó (DETECTOR)
F þóöú (key in the detector’s address)
B /RFNWKHSDQHODJDLQ
with the key
Remember to de-isolate the detector later.
Further information can be found in the chapters
The Operating Menus’, page 22 and "The
Operating Menus", page 22.
+RZWRGHLVRODWHDGHWHFWRU
When you later want to de-isolate the detector —
for example detector ‘0245’ — you must press
the following keys on the numeric keypad:
B 8QORFNWKHSDQHO
with the key
F M (PDLQPHQX)
F ó (ISOLATE / DE-ISOLATE)
F  (DE-ISOLATE)
F ó (DETECTOR)
F þóöú (key in the address of the
detector)
B /RFNWKHSDQHODJDLQ
with the key
&KHFNLQJDFWLYHLVRODWLRQV
If you want to check which units — detectors,
loops or alarm outputs — are isolated, you must
press the following keys on the numeric keypad:
B 8QORFNWKHSDQHO
with the key
F M (PDLQPHQX)
F ó (ISOLATE / DE-ISOLATE)
F ì (DISPLAY ISOLATIONS)
the
display now shows an isolated unit
F  (shows the next isolated unit)
F  (shows the next isolated unit)
When you are finished scrolling
through all isolations,
F M (PDLQPHQX)
B /RFNWKHSDQHODJDLQ
with the key
Further information can be found on page 23,
"The Operating Menus".