108 ESR Series Routers Operation Manual
Reset to factory default is similar.
esr# copy system://factory-config system://candidate-config
How to attach subinterface to created VLAN?
While subinterface creation, VLAN is created and attached automatically (direct correlation index
sub-VID)
esr(config)# interface gigabitethernet 1/0/1.100
Information messages are shown after applying:
2016-07-14T012:46:24+00:00 %VLAN: creating VLAN 100
Do the ESR-series routers have features for traffic analysis?
Opportunity of analysing traffic through CLI interfaces is realized on ESR-series routers. A packet sniffer
is launched by monitor command.
How to configure ip-prefix-list 0.0.0.0./0?
Example of prefix-list configuration is shown below. The configuration allows route reception by
default.
esr(config)# ip prefix-list eltex
esr(config-pl)# permit default-route
Problem of asynchronuous traffic transmission is occurred
In case of asynchronous routing, Firewall will forbid "incorrect" ingress traffic (which does not open
new connection and does not belong any established connection) for security reasons.
Allowing rule in Firewall does not solve the problem.
Firewall should be disabled on ingress interface.
esr(config-if-gi)# ip firewall disable
To Next Page
Loading...
