ESR Series Routers Operation Manual 53
To check the routing table, use the following command:
esr# show ip route
7.11 MLPP configuration
Multilink PPP (MLPPP) is an aggregated channel that encompasses methods of traffic transition via
multiple physical channels while having a single logical connection. This option allows to enhance
bandwidth and enables load balancing.
Fig. 7.9—Network structure
Objective: Configure MLPPP connection to the opposite side with IP address 10.77.0.1/24 via MXE
device.
Solution:
Switch gigabitethernet 1/0/10 interface into E1 operation mode:
esr# configure
esr(config)# interface gigabitethernet 1/0/10
esr(config-if-gi)# description "*** MXE ***"
esr(config-if-gi)# switchport mode e1
esr(config-if-gi)# switchport e1 slot 0
esr(config-if-gi)# exit
Enable interface e1 1/0/1, interface e1 1/0/4 into MLPPP 3 aggregation group:
esr(config)# interface e1 1/0/1
esr(config-e1)# ppp multilink
esr(config-e1)# ppp multilink-group 3
esr(config-e1)# exit
esr(config)# interface e1 1/0/4
esr(config-е1)# ppp multilink
esr(config-е1)# ppp multilink-group 3
esr(config-е1)# exit
Configure MLPPP 3:
esr(config)# interface multilink 3
esr(config-multilink)# ip address 10.77.0.1/24
esr(config-multilink)# security-zone trusted
esr(config-multilink)# exit
esr(config)# exit
Configuration changes will take effect when the following commands are executed:
esr# commit
Configuration has been successfully committed
esr# confirm
Configuration has been successfully confirmed
esr#
To Next Page
Loading...
