18 ESR series routers
6.6. Basic setting application
Enter next commands from command interface root section to confirm router configuration
changes.
esr-1000# commit
esr-1000# confirm
If you used remote access to the device and network parameters of a control interface were
changed than connection with the device could be lost after entering of commit command. Use new
network parameters specified by configuration for connection to the device and enter confirm command.
If you couldn’t enter confirm command then the device configuration returns back into the
previous state (state before entering of the commit command) after the end of the acknowledgment
timer.
6.7. Checking the adjustment
Try to get access to the website http://eltex.nsk.ru from the «trusted» zone for settings verification.
If you got access it means traffic passes through a service router. If you didn’t get access – check settings
verification.
To Next Page
Loading...
