12
3. Safety
3.1 Warnings
• This is a single-user product. Use by more than one person may present a health risk
and voids the warranty
• Inspect for damage, clean and sterilize washable components that come into
contact with your breast and breast milk prior to first use
• Clean all parts that come into contact with your breast and breast milk and inspect
for damage after every use
• During normal use areas of the Elvie Pump may warm up. If your pumping
environment is at the upper operating temperature limit (30°C) for the maximum
session time (40 minutes) the temperature of the Breast Shield may reach up to 43°C
• The black semicircle on the base of the Hub uses infrared (IR) energy to monitor the
milk volume in the bottle when Elvie pump is pumping. Ensure the black semicircle
does not come into direct contact with skin while Elvie Pump is pumping
• Do not store wet or damp parts as mould may develop
• Do not immerse the Hub in water or other liquid. Wipe with a clean, damp cloth
• This product contains small parts and a cable that may present a hazard. Keep out
of the reach of children
• Only use Elvie manufactured parts with Elvie Pump, including the Charging Cable;
do not substitute
• It is recommended to use an adaptor compatible with IEC 60601-1 and with your
regional power source
• Do not drop or insert any foreign object into any openings on the Hub and always
close the charging cap after charging
• Never operate an Elvie Pump if it has been damaged, is not working properly, or
has been dropped into water. If damage is found, immediately discontinue use and
Read all instructions before using. Elvie Pump is not provided sterile.
It must be cleaned and sterilized before first use (see section 4.3).
When using electrical products, especially when children are present, basic safety
precautions should always be maintained, including the following:
To Next Page
Loading...
