EM TEST dito Short Manual

EM Test ditoControl
Short form Introduction V 2.04 3 / 15
1 dito: Operation
1.1 dito: Starting up
Parts 1 dito base unit
2 Discharge Module
3 Discharge Tip
3a Contact discharge
3b Air discharge
4 Battery
Operation 5  Button
6  Button
7 Function keys F1...F5
8 Display
9 Trigger and ON/OFF
Connections 10 Optical Interface
11 Ground Cable
Switching On – Switching Off
ON Push trigger button (9) once
OFF Push trigger button (9) for 3s
Start-up Display
After switching ON, dito starts a self test routine to check the
basic function of the unit including the high voltage power supply.
The R/C discharge parameters of the module are displayed in the
lower line.
In case that there is no discharge module connected, dito will
show the message
No Discharge Module .
By pressing the trigger button once again you can get into the
main menu.

EM TEST dito Specifications

General

Brand	EM TEST
Model	dito
Category	Test Equipment
Language	English