EM TEST dito Short Manual

EM Test ditoControl
Short form Introduction V 2.04 4 / 15
1.2 dito: Main Menu
Easy ZAP
Quick ZAP
Evaluation
Test Routines
Setup
Easy Zap is based on “Standard Test Lev-
els”. After pressing Start, the operator can
select the required test level with the func-
tion keys and with
the polarity can be changed.
Within Quick Zap the test voltage can be
changed with the function keys
while running a test. With buttons the
polarity can be changed. The value  U per
step can be selected in the Service Menu
under Setting. Evaluation
This test routine helps to search for most
sensitive test points at the DUT. The dis-
charges are released with a higher repetition
rate. This routine is normally not used for
final testing at the preselected test points.
The dito includes 8 standard routines, which
the operator can preprogram on his own by
using the „ditoControl“ software. The data
can be downloaded via the optical interface.
The Standard Routines will guide the user
through the complete test procedure.
Hardware and software settings are made in
this menu.
- The standard test levels for AD and CD
can be set.
- Hardware settings
- Firmware settings

EM TEST dito Specifications

General

Brand	EM TEST
Model	dito
Category	Test Equipment
Language	English