To Next PageTo Next Page
Need help?Do you have a question about the EM TEST CNI 503 Series and is the answer not in the manual?
General| Power Supply | 100-240 VAC, 50/60 Hz |
|---|---|
| Application | Conducted Immunity Testing |
| Standard | IEC/EN 61000-4-6 |
| Output Impedance | 150 Ohm |
| Modulation | AM |
| Standards Compliance | IEC/EN 61000-4-6, IEC/EN 61000-4-16 |
| Interface | USB |
Lists coupling networks for IEC pulses with specifications.
Lists coupling networks for IEC, ANSI, and Ringwave standards.
Details special coupling networks and their specific configurations.
Describes the front panel controls and indicators of the CNI 503.
Details the rear panel connectors and their functions on the CNI 503.
Describes the front and rear views of the CNI 501 S1 model.
Explains different coupling modes for surge and burst tests.
Discusses coupling transients to signal and data lines.
Details the EUT power supply requirements for various coupling networks.
Lists the DC current capabilities of CNI 503Nx models based on time constant.
Highlights differences in technical data for special CNI 503 devices.
Provides general technical information including DC supply, coupling modes, and dimensions.
Specifies test levels for Burst pulses based on IEC 61000-4-4 Ed.2.
Lists decoupling inductor values for surge pulses based on rated current.
Explains how to connect the EUT power supply to the coupler.
Details the synchronization process for surge and burst tests.
Describes how to connect DC power supplies and external DC contactors.
Explains operating the CNI 503 with generators or internal CDN.
Details correct grounding procedures for the test setup.
Explains surge coupling to signal and data lines using CNV504/508.
Describes burst coupling using an HFK capacitive coupling clamp for signal lines.
Outlines the test setup for CNI 503 with UCS500N5E/N5V generators.
Details test setup for CNI 501/503 with EFT/VCS 500 generators.
Describes test setup with CNI 501 BS3 or CNI 503B7.5.
Details the CNI 501B9 special coupling network.
States the coupling network requires no maintenance.
Outlines factory calibration, guidelines, and in-house verification.
Lists the basic equipment included in the delivery.
Details available accessories and options like K-VCS-500R.
Declares conformity with EC directives and relevant standards.
Details 32A and 100A plugs and sockets from Multi Contact.
Explains the Multi Contact MC Locking system (AR-system) for connections.
Describes 100A DC plugs and connectors from Multi Contact with bayonet locking.
Presents general diagrams for coupling capacitors, resistors, and inductances.
Details maximum theoretical inrush current values for CNI 503 based on supply voltage and frequency.
