EMB Wallenstein CR60 - Battery Safety; Refueling Safety; Tire Safety

15
2.12 REFUELING SAFETY
1. Handle fuel with care. It is highly ammable.
2. Allow engine to cool for 5 minutes before re-
fueling. Clean up spilled fuel before restarting
engine.
3. Do not refuel the machine
while smoking or when near
open ame or sparks.
4. Fill fuel tank outdoors.
5. Prevent res by keeping machine clean of ac-
cumulated trash, grease and debris.
2.13 TIRE SAFETY
1. Failure to follow proper procedures when
mounting a tire on a wheel or rim can produce
an explosion which may result in serious
injury or death.
2. Do not attempt to mount a tire unless you
have the proper equipment and experience to
do the job.
3. Have a qualied tire dealer or repair service
perform required tire maintenance.
4. When replacing worn tires, make sure they
meet the original tire specications. Never
undersize.
2.14 BATTERY SAFETY
1. Keep all sparks and ames away from batter-
ies, as gas given off by electrolyte is explo-
sive.
2. Avoid contact with battery electrolyte: wash
off an spilled electrolyte immediately.
3. Wear safety glasses when working near bat-
teries.
4. Do not tip batteries more than 45°, to avoid
electrolyte loss.
5. To avoid injury from spark or short circuit, dis-
connect battery ground cable before servicing
any part of the electrical system.