EMC VNX5500 - Page 65

I/O modules
VNX5500 Hardware Information Guide 65
Note: This I/O module requires software release VNX OE for File 7.0 to function properly. It
will not function properly in software release VNX OE for File 7.1. Use the newer I/O
module (version 3) of the two-port 10-Gb/s Ethernet optical or active Twinax I/O module
as described in the “Two-port 10-Gb/s optical I/O module” section on page 66.
Figure 58 Two-port 10-Gb/s optical I/O module
Two-port 10-Gb/s optical I/O module LEDs
The two-port 10-Gb/s optical I/O module has three types of status LEDs. Figure 59 shows
the LEDs and Table 37 on page 66 describes them.
Figure 59 Two-port 10-GbE optical I/O module LEDs
1 Push button latch handle 4 SFP+ link LED (right)
2 Power/fault LED 5 SFP+ NIC activity LED (left)
3 SFP+ (optical) port (two)
1
0
1
2
3
4
5
CNS-001756
1
0
Link LED
Link LED
Activity LED
Activity LED
CNS-001672
Power/fault LED