EMC2 VNX Series Quick Start Guide

you installed the I/O modules correctly, and then initiates coordinated reboots of the
SPs, during which the storage system continues to operate.
Procedure
1. Start the Unisphere Service Manager, if you have not already done so, by doing either
one of the following:
l
Click the Unisphere Service Manager icon on your desktop, or
l
Select Start > All Programs or Start > Programs, then select EMC > Unisphere >
Unisphere Service Manager > Unisphere Service Manager.
2. Log in to your system.
3. From the System screen, select Hardware > Hardware Installation > Install I/O
modules and/or SFPs.
4. Follow the instructions that appear.
Verify the new component
Follow the tasks presented below to verify the functionality of the newly installed
component.
Verifying the operation of a new or replacement part with Unisphere
Procedure
1. Start EMC
®
Unisphere for the storage system by entering the IP address in a browser
window.
2. In the system drop-down list on the menu bar, select the system in which you
installed or replaced the part.
3. Select System > Hardware > Storage Hardware.
4. Expand the enclosure in which you installed or replaced the part, and navigate to the
part.
5. Verify that the part is in the enclosure and that it is not faulted.
Checking the system for faulted hardware
Follow the steps below to verify the status of the system's hardware components.
Running the Verify Storage System wizard
Use the Verify Storage System wizard to perform a health check on the storage system.
Procedure
1. Start the Unisphere Service Manager by doing either one of the following:
l
Click the Unisphere Service Manager icon on your desktop
l
Select Start > All Programs or Start > Programs, then select EMC > Unisphere
Service Manager > Unisphere Service Manager
l
From the System screen in Unisphere, click Launch USM in the right-hand taskbar
located under Service Tasks
2. Log in to your system.
3. From the System screen, select Diagnostics > Verify Storage System to run the storage
system health check wizard.
Adding Storage Processor I/O modules and SFPs
Verify the new component 7

EMC2 VNX Series Specifications

General

Brand	EMC2
Model	VNX Series
Category	Storage
Language	English