Setting the Filter Cycles - SS-1D ONLY
The filter cycle duration is programmable via the topside panel. Press the pad, then the pad, and
"F3" will be displayed on the panel. "F3" is the default filter time and indicates a 3 hour cycle. Press the
pad again to cycle through the rest of the filter time options; "F6" = 6 hours, "F9 = 9 hours, and "FC" = 12
hours. After you have selected your duration, press the pad again to exit the programming.
Center Display Messages
These are some of the messages you may see on the center display.
Overheat (Spa is deactivated)
The spa has shut down. DO NOT ENTER THE WATER! Turn off all power to the spa and call
your dealer or service organization. To reset the spa, press any panel button.
Flow
A pressure switch is not working. Call your dealer or service organization.
Sensor
The high-limit sensor or water temperature sensor is not working. Call your dealer or service
organization.
Spa Side Control
Panel SS-1D
[continued]
21
Features and Controls
To Next Page