Temperature
(Standby) Setback
Note:
Turning air intake controls off
prevents air from entering the
water and helps reduce heat loss.
During those times when the spa will not be used for extended periods. (ex. vacations)
1. Adjust the temperature setting to 60
o
F.
2. Turn air intake controls off.
3. Cover the spa to reduce heat loss and evaporation, and to prevent unauthorized use.
ON OFF
(MAX) (MIN)
SpaceSaver II
Filtration System
Diagram
Relamping the
Underwater Light
Caution:
Do not attempt to remove or reinstall the light lens without using
the proper tool provided.
The underwater light should be relamped from the under side of the spa as follows:
1. Disconnect the power from the spa.
2. Locate the light fixture on the back of the spa inside the cabinet.
3. Remove the old bulb and install a new bulb.
48
Emerald Whirlpool Spa Owner's Manual
To Next Page
Loading...