REFRIGERANT CYCLING HEAT PUMP WATER HEATER
USER MANUAL
SAFETY INFORMATION
Read these instructions carefully before installation.
Keep this manual in a handy for future reference.
Improper installation of equipment or accessories may
result in electric shock, short-circuit, leakage, fire or
other damage to the equipment. Be sure to only use
accessories made by the supplier, which are specifically
designed for the equipment and make sure to get
installation done by a professional.
All the activities described in this manual must be carried
out by a licensed technician. Be sure to wear adequate
personal protection equipment while installing the unit
or carrying out maintenance activities.
Contact your dealer for any further assistance.
MODEL NUMBERS:
EE-HWS-RCHP-200 EE-HWS-RCHP-200E
EE-HWS-RCHP-300 EE-HWS-RCHP-300E
Thank you for choosing Emerald Energy.
This leaflet contains important information on the correct
installation and operation of your heat pump water heater.
CONTENTS
SAFETY PRECAUTIONS 2-3
GENERAL INTRODUCTION 4
- Outdoor unit 4
- Water tank 4
BEFORE INSTALLATION 5
- Accessories 5
- Space for maintenance 5
INSTALLATION PROCEDURE 6-9
- Dimension sketch 6
- Drain hole position 7
- Pipe connection 7
- Vacuum drying 8
- Refrigerant charge 9
ELECTRICAL CONNECTION 10-12
- Power supply cords 10
- Electrical wiring diagram 11
- Water tank temperature sensor installation 11
- ODX & AUX power connection 12
CHECK 13
OPERATION AND PERFORMANCES 14
MAINTENANCE 15
- Confirmation before running 15
- Troubleshooting 15
- After sales service 15
- Important refrigerant information 15
ERROR CODE TABLE 16
POWER SUPPLY: 220V-240V/1N~50Hz
ENVIRONMENT TEMPERATURE: -15°C 46°C
Working water temperature: Min inlet water temperature 5°C,
Max outlet Water Temperature 60°C.
To Next Page
Need help?
General
