Emerson CKS9051 - Alarm Sounds and Sleep Timer; Wake To Buzzer and Snooze; Sleep To Music Timer

+ Alarm 1 is a “Single beep” sound. + Alarm 2 is a “Double beep” sound.
You will be able to tell which alarm is going off by the sound that it makes.
1.) Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both alarms.
2.) Set the ALARM selector switch for one or both alarms to the BUZZER
position. The appropriate ALARM 1 and/or ALARM 2 indicators will light up
to confirm that the alarms are set.
3.) At the selected wake up time the buzzer will sound. It will begin softly and
gradually increase in volume to wake you up. It will continue for one hour and
then shut off automatically.
4.) To stop the buzzer sooner, press either the appropriate ALARM 1 or
ALARM 2 button. The buzzer will stop but the alarm remains set and will turn
the buzzer on again at the same time on the following day (depending on the
Alarm Mode setting).
5.) To stop the buzzer and turn on the radio immediately, press the RADIO ON/OFF
button twice instead of the ALARM 1 or ALARM 2 button.
6.) If you do not want the alarm to turn the buzzer on the following day, set the
appropriate ALARM selector to the “OFF” position.
Radio And Buzzer Operation
You may also set one alarm for “Wake To Radio” and the other for “Wake To Buzzer’.
Just set the ALARM 1 and ALARM 2 selector switches to the desired positions.
Snooze Alarm
After the radio or buzzer alarm sounds in the morning you may press the SNOOZE
Bar for a few more minutes sleep. The respective ALARM indicator will flash.
The alarm will stop for approximately 9 minutes and then turn on again. You may
repeat the Snooze operation up to seven times if desired, but after the seventh
time the alarm will not turn on again.
Sleep To Music Timer
You can program the Sleep Timer to play the radio for up to 90 minutes and then
shut off automatically.
1.) Press the SLEEP button. The display will briefly : {}
show “10” and the radio will begin to play.
After 10 minutes the radio will shut off automatically. Each time you press the
SLEEP button the Sleep Timer will start at 10 minutes. This is the Sleep Timer
default setting.
2.) To increase or decrease the amount of time that the radio will play before
shutting off, hold the SLEEP button and press either the SET » (Up) or
SET < (Down) button to change the display to the desired Sleep Time, up toa
maximum of 90 minutes or a minimum of 2 minutes.
Note: When you change the Sleep Timer from the 10 minute default setting
to a different setting, the new setting becomes the default setting. Whenever
11