Emerson CKS9051 - Display and Battery Maintenance; Dimmer Control Adjustment; Replacing the Lithium Battery

you activate the Sleep Timer it will begin with your new default setting and
count down to zero from that point.
3.) To cancel the Sleep Timer before it counts down to “00” and shut the radio ‘Off.
immediately, press the SNOOZE Bar.
IMPORTANT: Remember that the station and volume settings you choose for
the Sleep To Music operation are the same settings you will hear if you set the
alarm for Wake To Radio the following morning.
Dimmer Control
The DIMMER control was set to the HI (High) position at our factory.
If you find the clock display is too bright in a darkened room, set the DIMMER
control to the LO (Low) position.
Changing The Lithium Battery
Like all batteries, eventually the built in lithium battery will need to be replaced. A
number of factors, such as, the length of time between the date the radio was
manufactured and the date you plugged it in for the first time determine the amount
of time before replacement. During this initial storage period, the lithium battery is
supplying power to the SmartSet® computer memory. Once you plug the radio in,
your household outlet supplies the power, and the battery is not being used.
A fresh lithium battery can supply power to the SmartSet® computer for at least 2
years even if it is never connected to an AC power supply. If your radio was
connected to your AC supply within a few months after it was manufactured, and
you experience only the normal, nuisance type, short duration power interruptions,
your battery may last for up to 5 years or even longer.
When the battery power drops below a certain level, the “AM” indicator will ‘flash’.
When you see this indicator, you should change the battery as soon as it is conv-
enient for you to do so.
To change the battery proceed as follows:
1.) Purchase a replacement 3V lithium battery wherever batteries are sold. The
battery type is CR2032 or equivalent.
2.) Remove the battery from its package so it is ready to install.
IMPORTANT: Leave the radio power cord connected to your AC outlet.
This will provide power to the SmartSet® computer memory while the
original lithium battery is removed.
3.) Tum the radio face down and use a small screw driver to remove the small
Screw securing the battery holder to the cabinet.
BE CAREFUL NOT TO LOSE THIS SMALL SCREW!
4.) Remove the original battery from the holder and insert the new battery into the
holder the same way, observing the postive (+) direction. Slide the holder with
the new battery back into the siot in the cabinet.
12