Emerson CKS9051 - Core Operating Instructions; Setting Time, Date, and Time Zones

1.) ALM 1 ‘On’ Indicator.
2.) AM Indicator.
3.) LOW BATT. ( CH )LED Indicator.
4.) Day LED Indicators.
5.) Time/Date Display.
6.) ALM 2 ‘On’ Indicator.
7.) Back Up Battery Compartment
(Bottom Cabinet).
8.) AC Power Cord (Back Cabinet).
9.) RADIO ON/OFF Button.
10.) TIME ZONE Button.
11.) MONTHIDATE Setting Button.
12.) TIME Setting Button.
13.) Speaker.
14.) SLEEP Button
(Sleep To Music Timer)
15.) ALARM MODE Button.
16.) ALARM 1 setting Button.
17.) ALARM 2 setting Button.
18.) SET < (Down) Button.
19.) SET > (Up) Button.
20.) SNOOZE (SLEEP OFF) Button.
21.) Display DIMMER (HIGH/LOW)
Switch.
22.) ALARM 2 (BUZZER/RADIO/OFF)
Selector Switch.
23.) ALARM 1 (BUZZER/RADIO/OFF)
Selector Switch.
24.) TUNING Control.
25.) Band(AM/FM) Switch.
26.) VOLUME Control.
27.) AUX IN JACK
OPERATING INSTRUCTIONS
Setting The Time, The First Time
IMPORTANT: The first time you connect your new SmartSet® clock radio to the
AC outlet the internal computer will automatically set the time correctly for the
Eastern Time Zone, which is the initial default setting. The display will scan for a
few seconds and then show the correct Day and Time in the Eastern zone. If you
live in the Eastern Time zone, there’s nothing else to do. Your clock is set correctly
and running.
If you do not live in the Eastern Time zone you must change the default zone
display to your own zone. You only do this one time and the SmartSet® will remember
the new default zone setting and will always return to that setting after a power
interruption
There are 7 time zones programmed into your SmartSet® clock radio as follows:
ZONE 1 — Atlantic Time ZONE 2 — _ Eastern Time (Default Setting)
ZONE3 — _ Central Time ZONE 4 — Mountain Time
ZONE5 — Pacific Time ZONE6 — _ Yukon Time
ZONE7 — Hawaiian Time