[] Initial Setup
Thissectionwill guideyouthroughthe unit'sinitialsettingwhichincludes
selectinga languageforyouron-screenmenuand"AUTOPRESETCH",which
automaticallyscansand memorizesviewable channels,
Before youbegin:
Makesureifthe unit isconnectedto antenna orcable.
1 After making all the necessary connections, press
[POWER] to turn on the unit.
• This operation may take a few moments.
2 Use [CH • / V] or [VOL _] to select the on-screen
language from the choices on the left side of the TV
screen. (ENGLISH / ESPANOL / FRAN_AIS)
or
OF
SELECTLANGUAGE
ENGLISH
NEXT:PRESSCHA
ESPANOL
DESPUES:PRESIONECHT
FRANQAJS
APRES:PRESSEZVOL
• Press [CH •] for English.
• Press [CH V] for Spanish,
• Press [VOL ] for French.
3 Use [CH • / V] to select"AUTO PRESET CH(TV/DTV)"
for TV channels or "AUTO PRESETCH(CATV)" for CATV
channels, then press [VOL _].
or
- INITIALSETUP -
I PLEASECONNECT ANTENNA
OR CABLE 0£ SATELLITE
TOTN]S UNIT
2 SET UPTHE [TENS WITH
iN AND A BUTTON£
'> AUTO PRESET OH(TV,_DW)
AUTO PRESET OH(CAW)
• Scanning and memorizing the channels automatically
start,
CH 25
AUTOPRESETCH(T_DTV)
• When the scanning and memorizing are completed,
the lowest memorized channel in the broadcasting
will be displayed.
EN
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press[POWER] or [MENU] during "AUTOPRESETCH",
thissetting will be canceled.
• Theinitial auto channel scan function can be executed for
either TV/D TVor CATVonly once. Ifyou wan t to scan both
TV/DTVand CATV,you need to select "CHANNELSETUP"in
the main menu to scan and memorize other channels after
initial presetting iscompleted. (Refertopage 11.)
• Youcan cancel or exit theinitial "AUTOPRESETCH" menu by
pressing [MENU].
• When no channel can be received by "AUTOPRESETCH",
"NOTVSIGNALS"is displayed on the TVscreen.
• If there isno signal input from the an tenna terminal and
no operation for more than 5seconds, "HELPFULHINTS"
appears. Follow the instructions listed on the TVscreen.
- HELPFUL HINTS -
1 PLEASE CHECK TO SEE FF
THE ANTENNA / CABLE /
SATELLITE iS PROPERLY
CONNECTED
2 DIDYOU PERFORM
"AUTO PRESET CH"?
3 PLEASE REFER TO FRONT
PAGE OF THE OWNER'S
MANUAL OR REAR PANEL
FOR SUPPORT LiNE
iNFORMATiON
[] Main Menu
Thissectiondescribestheoverviewofthe mainmenudisplayedwhenyou
press[MENU],
Formoredetails,seethe referencepageforeachitem,
Themainmenuconsistsofthefunctionsettingitemsbelow,
Press [MENU].
O
e.g.) digital TV mode
- WSETUP -
_" PICTURE
CHANNELSETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OPP]
DTV SETUP
• PICTURE
You can adjust the picture quality,
(Refer to "Picture Adjustment" on page 16,)
• CHANNEL SETUP
You can automatically scan the viewable channels and
remove those that are undesired.
(Refer to"Auto Channel Scan"on page 1I,)
• V-CHIP SETUP
You can set the viewing limitations,
(Refer to "V-chip" on page 19,)
• LANGUAGE
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to "Language Selection" on page 11 .)
• CAPTION
You can change the display format for closed caption,
which displays the dialogue of a TV program or other
information across the TV screen,
(Refer to "Closed Caption" on page 16.)
• DTV SETUP
You can set the screen display or caption in the DTV
mode,
(Refer to "DTV Closed Caption" on page 17.)
To Next Page
Loading...
Need help?
General
