1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx iProCHILL 10/205
Complete management of pump down function:
With dedicated pressure switch
Timed
Via the low pressure switch
Via the low pressure transducer
Circuit unloading function:
From high evaporator inlet water temperature
From low evaporator outlet water temperature
From high condensing temperature/pressure
From low evaporator pressure
Anti-freeze function:
From low evaporator temperature
From low condenser temperature
From digital input as anti-freeze alarm
Active with four heaters
Domestic hot water production function:
From low temperature of domestic hot water control probe
Take effects by compressors and heaters working with step regulation
Manage domestic hot water pump and valves
Antilegionella function:
From RTC time band setting
Take effects by domestic hot water production
Solar panels water pump management:
From high solar panel NTC temperature probe temperature
Manage solar panel water pump and solar coil enabling/exclusion ON/OFF valve
Free-cooling function:
From high system water inlet temperature and low external air temperature
Manage Free-cooling ON/OFF valve and Free-cooling ON/OFF fan
Mange modulating output free-cooling mixer valve and hot water three-way valve
Controlled loads maintenance signal function:
Compressors
Evaporator pumps
Condenser pump
Circuit auxiliary relay function:
Four completely configurable relay outputs, also released from normal working of the unit controlled,
managed by means of NTC or PTC temperature probes or with 4÷20mA – 0.5 Volt pressure transducer
Weekly working in energy saving mode:
Up to three daily time bands (devices with RTC option)
From digital input
Weekly working with automatic switch on and switch off:
Up to three daily time bands (devices with RTC option)
Dynamic set-point function:
Managed by NTC or 4÷20mA input
Changeover function:
Automatic changeover between cooling and heating by NTC input
Remote OFF function:
From configurable digital input
Remote heating cooling function:
From digital input with configurable logic
Supply fan hot start function:
Air/air unit
Defrost management:
In temperature in pressure or with both (combined control)
Forced defrost for start-up with low external air temperatures
From digital input or timed
Manual using the relevant key
By hot gas or fan only