1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx iProCHILL 83/205
6.8.1 Parameters programming
By selecting this menu it is possible to modify the value of the parameters depending on the password level.
The parameters are divided per groups with the following meaning:
Display temperature control parameters
Display variables to be shown on the keyboard
Display configuration parameters
Display parameters for machine set up
Display dynamic set-point parameters
Display energy saving and automatic timed switch-on/off parameters
Display auxiliary heating parameters
Display compressor parameters
Display stepless compressor parameters
Display evaporator/condenser water pump parameters
Display pump down function parameters
Display unloading function parameters
Display ventilation parameters
Display anti-freeze heaters parameters
Display defrost parameters
Display heat recovery parameters
Display production of domestic hot water parameters
Display free-cooling function parameters
Display auxiliary output parameters
Display parameters for the management of the electronic expansion valve
Display inputs/outputs configuration parameters
Display analog input calibration parameters
Display analog input range parameters
According to user level, different amount of parameters are visiable in the parameters programming screen.
If user entered into SERVICE menu with 1
st
level, he can enter to see parameters in Level 1(Pr1).
If user entered into SERVICE menu with 2
nd
level, he can enter to see parameters in Level 1(Pr1) and
Level 2(Pr2).
If user entered into SERVICE menu with 3
rd
level, he can enter to see parameters in Level 1(Pr1), Level
2(Pr2) and Level 3(Pr3).
In the selected level screen, user only can see parameters with equal or lower protecting level.
For example: When enter into 2
nd
level parameters screen, only parameters with Pr1 or Pr2 are displayed.