Emerson EAD70E1 - Error Code

Problem
Possible Causes
Solutions
Frost appears on
the coils
• The dehumidifier has recently been
turned on or the room temperature is
below 41 °F(5°C).
• This is normal. Frost will usually disappear within
60 minutes.
Controls cannot be
set
• The compressor will turn off and the
fan will automatically continue to run
for approximately 3 minutes at a fixed
setting.
• This is normal. Wait approximately 3 minutes and
set the fan speed at the desired level.
• Air is moving through the unit.
• This is normal.
Water on the floor
• Hose connection may be loose.
• Check the hose connection. See the
CONTINUOUS MODE-GARDEN HOSE INSTALLATION
AND SET UP Section.
• Hose is attached but not draining
• Disconnect the hose if using the bucket; place
the hose near a drain.
ERROR CODE
For any questions or Technical Support,
Please call customer service:1-844-882-2622
Or email: serviceweb@canac.ca
Error Code
Description
EH
Humidity Sensor Fault
El or E2
Temperature Sensor Fault
E3
Lack of gas