Emerson EHS -2000 - Bluetooth Pairing and Connection

13
For first time use or re-pairing, pair the unit to an external Bluetooth (BT) device
~ Press the
~
5. During playing:
~ Press the or button on remote control to skip tracks.
1. Power on the unit and select the Bluetooth mode as above stated.
2. Activate the Bluetooth function on external Bluetooth device.
3. After a few seconds the unit will automatically connect to the external
Bluetooth device.
4. Play the music as stated above.
BLUETOOTH PAIRING AND CONNECTION
button on remote control or the Play/Pause button on the unit
to pause. Press again to resume normal playing.
~
~ Press the Vol- or Vol + button to adjust volume level.
Note: When the volume is set to the highest level, a beep will sound to notify it.
Normal operation after first time pairing:
as below:
1. Power on the unit as previously explained.
2. Press the Standby/Source button on the unit or press the SOURCE button
on remote control. The indicator will blink in blue, and a voice tone sounds
"Bluetooth Mode".
3. Power on the external Bluetooth device and switch on Bluetooth. When
"EMERSON EHS-2000" appears, select it and start pairing.
4. After paired, the indicator will stop blinking and a beep will be heard, which
both indicating the Bluetooth connection is established. (For details on pairing
steps, please refer to the user's manual of your Bluetooth device.)