Emerson EWD2004 - Page 44

AN1
AN2
AN3
AO1
AO2
AO3
AP1
AP2
AP3
AQ1
AQ2
AQ3
AN4
AO4
AP4
AQ4
AR1
AR2
AR3
AR4
1-10-17
1-10-18
H9600SCM8
Main 8/8 Schematic Diagram < VCR Section >
NOTE :
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
A V
F
CAUTION
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,
REPLACE ONLY WITH THE SAME TYPE FUSE.
ATTENTION : POUR UNE PROTECTION CONTINUE LES RISQES
D'INCELE N'UTILISER QUE DES FUSIBLE DE MÊME TYPE.
RISK OF FIRE-REPLACE FUSE AS MARKED.
"This symbol means fast operating fuse."
"Ce symbole reprèsente un fusible à fusion rapide."
CAUTION !
Fixed voltage ( or Auto voltage selectable ) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown, check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
MAIN 8/8
Ref No. Position
IC1001 AP-1
Q031 AQ-1
Q1001 AP-3
Q1003 AO-3
Q1008 AO-2
TRANSISTORS
ICS