Emerson Fincor 2331BP1 - User Manual

50 pages

Save Page as PDF

To Next Page

BOOK 0958-B

Series 2330MKII

Single-Phase

Adjustable-Speed

DC Motor Controllers

(1/6 – 3 HP)

Control Techniques

3750 East Market Street

York, PA 17402-2798

717-751-4200, FAX 717-751-4263

www.fincor.net

Get other manuals https://www.bkmanuals.com

Questions and Answers

E
emilymorganAug 8, 2025
How to troubleshoot Emerson Controller when motor won’t start?
- D
  Debra SantosAug 8, 2025
  If the motor won’t start with the Emerson Controller, first ensure the rated AC line voltage is applied to the controller. Check that the operator controls are functioning correctly and connected properly. Verify that a wire jumper or switch connects E1 to E2, closing the circuit. Try initiating a Stop command and then a Start command to reset the controller. Make sure +24 VDC is applied to Terminal TB2 8 to enable the controller. Check for a 0 - 10 VDC speed reference signal. Turn the ACCEL and CUR LMT potentiometers fully counterclockwise (100%). Check the motor shunt field and associated circuitry for a loose connection or a broken wire. Repair or replace the motor if it has failed, or replace the control board if it has failed.
M
Melissa ChristianAug 22, 2025
What to do if Emerson Fincor 2331BP1 line fuse blows?
- N
  Nicole HarrisAug 22, 2025
  If the Emerson Controller line fuse blows when AC line power is applied, it could be due to several reasons. First, check all external wiring terminating in the controller and correct any faults. It's also possible there's a circuit, component, or wiring grounded, which needs to be removed. Other potential causes include shorted SCR1, SCR2, SCR3, or SCR4; a shorted Bridge Diode D1b; a shorted Varistor RV1; shorted Shunt Field Diodes D39, D40, D41, or D42; a shorted or grounded motor shunt field; or a control board failure. Replace the shorted components or the control board as necessary and repair or replace the motor if the shunt field is shorted or grounded.