Instruction Manual
D100423X012
V500 Valve
July 2017
26
Key Description
13* Packing Set (continued)
PTFE/bound composition rings
Single & purged bearing construction
Conductive ‐ 3 req'd & graphite filament ring
Nonconductive ‐ 4 req'd
Double or Leakoff
Conductive ‐ 5 req'd & graphite filament ring
Nonconductive ‐ 6 req'd
Graphite filament ring ‐ 1 req'd
use with PTFE/bound composition conductive packing
Graphite ribbon rings
Single & purged bearing construction ‐ 4 req'd
Double or Leakoff ‐ 6 req'd
14 Packing Follower, CF8M (316 SST)
15 Packing Flange Stud (2 req'd)
16 Packing Flange Nut (2 req'd)
17* Packing Box Ring, S31600
18 Lantern Ring, S31600
19* O‐Ring (for sealed bearings; 2 req'd)
20* O‐Ring (for sealed bearings; 2 req'd)
21 Anti‐seize lubricant (not furnished with valve)
22 Nameplate, SST
23 Drive Screw, SST (6 req'd)
24 Pipe Plug, S31700
24 Isolator/Lubricator Valve (not shown)
Pipe nipple (not shown)
25 Cap Screw
26 Hex Nut
Key Description
28* Packing Washer (not shown)
Zinc (for graphite/ribbon pkg only)
Single ‐ 3 req'd
Double or leakoff ‐ 4 req'd
30 Nameplate (not req'd when actuator is furnished)
31 Nameplate Wire, steel (not req'd when actuator is furnished)
32 Flow Arrow, SST
33 Retainer Tool, steel (not shown)
36 Line Studs (for flangeless valve bodies)
37 Cap Screws (for flangeless valve bodies)
130 Clamp SST (req'd w/ nonconductive packing)
131 Bonding Strap Assembly (req'd w/nonconductive packing)
ENVIRO‐SEAL Packing System
(figure 14)
100 Packing Flange Stud (2 req'd)
101 Packing Flange Nut (2 req'd)
102 Packing Flange, SST
103 Spring Pack Assembly
105* Packing Set
106* Anti‐Extrusion Ring, Composition/graphite filled PEEK (2 req'd)
107* Packing Box Ring
108* Packing Ring
109* Anti‐Extrusion Ring
*Recommended spare parts
To Next Page
Loading...
