Emerson LC320EM3F

English
13
4 Use your TV
Switching on your TV and putting it in standby
mode
VOLUME CHANNEL MENU SOURCE POWER
POWER
To Turn Power On or to Turn Standby On
• Press
.
on the front panel or the remote control.
Note
• Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
Adjusting volume
VOLUME CHANNEL MENU SOURCE POWER
VOLUME
To increase or decrease volume
• Press VOLUME (down) / (up) on the front panel or press
VOL + / − on the remote control.
To mute or unmute sound
• Press on the remote control to mute the sound.
• Press
again or VOL + / − to recover the original sound.
Switching channels
VOLUME CHANNEL MENU SOURCE POWER
CHANNEL
To select Channels by using CHANNEL ▲/▼ or CH + / −
• Press CHANNEL ▲(up) / ▼(down) on the front panel or press
CH + / − on the remote control.
To select Channels by using the NUMBER buttons
Digital TV operation
• For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Analog/Cable TV operation
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note
• To select the non-memorized channels, use the NUMBER buttons.
• No Signal will appear on the TV screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV screen, when you receive only
sound signal.