Installation
5
4.2 Rack Mount Installation
1. Rack mount installation of the Liebert MicroPOD is possible with the use of the rack mounting
brackets (shipped with the Liebert MicroPOD). See Figure 5.
2. The rack mount brackets allow you to rack mount the Liebert MicroPOD in a 19" enclosure.
3. The Liebert MicroPOD can be mounted to face one of four directions depending on your
application, utilizing the rack mount brackets provided.
4. Determine the desired position and direction for the Liebert MicroPOD, face it in that direction,
then attach the brackets to the Liebert MicroPOD with the screws provided.
5. Consult your rack/enclosure manufacturer’s recommendations for specific rack mounting
hardware that will be required.
6. The holes on the rack mount bracket are notched for easy installation. Tighten the Liebert
MicroPOD securely to the rails and then follow the startup directions for the Liebert MicroPOD in
4.1 - Installation on a Liebert GXT UPS.
Figure 5 Liebert MicroPOD mounting bracket location
!
CAUTION
Before installing, open all branch rated circuit breakers at the nearest disconnect, turn UPS
off and disconnect all cords to and from the UPS.
Mounting
Bracket
Mounting Bracket
To Next Page
Loading...
Need help?
General
