Need help?Do you have a question about the Emerson MultiFlex 88 and is the answer not in the manual?
General| Power Supply | 24 VDC |
|---|---|
| Agency Approvals | CE |
| Input Type | Analog |
| Output Type | Analog/Digital |
| Humidity Range | 5% to 95% non-condensing |
Guidance on powering MultiFlex boards from a 24VAC source.
Criteria for selecting the appropriate transformer VA rating for MultiFlex.
Specific power wiring instructions for the MultiFlex 16 board.
Power wiring procedures for MultiFlex Combination I/O boards.
Power wiring for new-style MultiFlex boards with isolated power supply.
Power wiring for old-style MultiFlex boards without isolated power supply.
Assigning unique network ID numbers to boards for controller communication.
Procedure for setting network ID numbers for the MultiFlex 16.
Guidelines for numbering MultiFlex Combination I/O boards.
Specifics on setting network ID addresses for the 168DO board.
Configuring the communication baud rate using dip switches.
Properly setting termination jumpers for RS485 network segments.
General information on MultiFlex input compatibility and operation.
Step-by-step instructions for wiring sensors to input points.
Specifics on input point terminals and signal connections.
Guidance for wiring compatibility when replacing older input boards.
Details on specific wiring types required for various sensors.
Overview of the Form C relay contacts and their operation.
To Next Page
