9
OPERATING INSTRUCTIONS
LISTENING TO THE RADIO
1.) To turn the system ‘on’, rotate the ON/OFF-VOLUME control clockwise until a
‘click’ is heard, and set the Volume to a low level.
2.) Set the Function selector (PHONO/CD/TUNER) to the TUNER position.
3.) Set the Band selector (AM/FM) to the desired band.
4.) Rotate the TUNING control to tune to the desired radio station. If you tune to a
strong FM Stereo station the FM ST Indicator will light and reception will be in
stereo. If you tune to a weaker FM station, the reception will automatically
switch to mono.
5.) Adjust the ON/OFF-VOLUME control to the desired level.
6.) When you are finished listening turn the ON/OFF-VOLUME control counter
clockwise until a ‘click’ is heard.
Antenna Information
The AM antenna is inside the cabinet. If AM reception is unsatisfactory try
repositioning the cabinet slightly until the internal antenna is picking up the strongest
signal.
The FM wire antenna is located on the back cabinet. If necessary adjust the position
and direction of this antenna until you find the position that provides the best
reception.
NR305TT_050704.p65 7/5/2004, 10:319
To Next Page
Loading...
