Emerson PNC001-A Series Important Product Information

GFK-2573AD May 2023
13
Functional Compatibility
The following CPU firmware and programming software versions are required to use the features
introduced in PNC001 release 2.00 and later:
Subject
Feature
Minimum Version Required
RX3i backplane
hardware
RX3i backplane hardware
The following minimum backplane hardware revision must
be used:
IC695CHS012-BAMP
IC695CHS016-BAMP
IC695CHS012CA-BAMP
IC695CHS016CA-BAMP
or
IC695CHS012-CA (or later)
IC695CHS016-CA (or later)
IC695CHS012CA-CA (or later)
IC695CHS016CA-CA (or later)
or
IC695CHS007-AA (or later)
When installing, operating, or maintaining the
IC695PNC001, personnel must ensure any electrostatic
charge is discharged through the use of a grounded ESD
strap or other means.
PLC CPU Firmware
Version
Requirements
RX3i PNC001 Release 3.20
IC695CMM002/004
support in IC695PNS001-
Bxxx, IC695PNS001, and
IC695CEP001
CPE330 Release 10.30
CPE310/CPE305/302 Release 10.30
RX3i PNC001-Bxxx Release
3.00
New Hardware & Firmware
to Resolve Component
Obsolescence
CPE330 Release 8.95
CPU320/CPU315 Release 8.95
CPE310/CPE305 Release 8.95
CRU320 Release 8.95
CPE302 Release 9.40
(Other CPU models are not supported)
RX3i PNC001 Release 2.26
Support Remote Get HART
Device Information
COMMREQ
CPE330 Release 8.95
CPU320/CPU315 Release 8.95
CPE310/CPE305 Release 8.95
CRU320 Release 8.95
CPE302 Release 9.40
(Other CPU models are not supported)

Emerson PNC001-A Series Specifications

General

Brand	Emerson
Model	PNC001-A Series
Category	Controller
Language	English