Quick Panel Operator User Manual Section 3
GFK-2847AA Jan 2023
Software 29
Figure 22: Sequence to Disable SNMP
3.10 Display Screen Sensitivity Tool
The QuickPanel
+
7”, 10”, 12”, and 15” display units use capacitive screen
technology that is far more responsive than the previously used resistive
touchscreen technology. Resistive screens required the operator to firmly
press down on the resistive overlay for a response. Capacitive screens
rely on the capacitive properties of the operator’s finger pressing lightly
on the screen.
If the operator is wearing gloves, this can affect the operation of the
capacitive screens. The thickness of the glove keeps the operator’s finger
slightly further from the screen. To accommodate gloved operation, the
Sensitivity Tool allows the screen sensitivity to be set to a higher level.
Setting the screen sensitivity to High enables the QuickPanel
+
display
screen to operate with the user wearing most types of work gloves. For
thicker gloves, the user may need to press down more firmly to place the
finger closer to the screen, which causes the finger pad to spread out
slightly to make a larger capacitive area.
Note: Gloved operation works best when the operator is wearing gloves that fit. If the fingers do not
extend to the end of the glove, the empty space at the fingertip may make it difficult to operate the
display screen while wearing gloves.
Setting the screen sensitivity to Low enables the QuickPanel
+
operator
actions to be slow and deliberate as they were using resistive screens.
With low sensitivity, the operator must press firmly down on the display
screen for a response.
To Next Page
Loading...
Need help?
General
