To Next PageTo Next Page
Need help?Do you have a question about the Emerson Rosemount 1151 and is the answer not in the manual?
General| Brand | Emerson |
|---|---|
| Model | Rosemount 1151 |
| Category | Transmitter |
| Language | English |
Introduces the guide and notes the product is discontinued.
Warns of explosion, injury, electrical shock risks during installation and operation.
Clarifies guide scope and refers to the reference manual for detailed instructions.
Mounting instructions for liquid flow applications, including tap placement.
Mounting instructions for gas flow applications, including tap placement.
Mounting instructions for steam flow applications, including impulse line filling.
Details installation using a pipe mount bracket, including torque specifications.
Details installation using a panel mount bracket.
Details installation using a flat mount bracket.
Emphasizes correct O-ring use for specific flange adapters to prevent leaks.
Guidelines for O-ring inspection, replacement, and re-torquing.
Instructions to rotate the transmitter housing for better LCD display access and viewing.
Specifies torque for the housing lock nut and use of sealing compound for watertight seal.
Illustrates field wiring and provides steps for connecting positive/negative leads.
Details proper grounding, cable trimming, and installing drip loops for safe wiring.
Describes DC power supply requirements including ripple and load resistance.
Details load limitations and operating regions based on supply voltage.
Instructions for setting the failure mode alarm switch to high or low alarm.
Explains the function of the write-protect switch and how to enable or disable it.
Lists essential configuration parameters to verify using HART communicator fast key sequences.
Describes LCD display components and basic operation, including time-out.
Steps to position the decimal point and select display modes like Linear or Square Root.
Procedure to set the display equivalent for a 4 mA input signal.
Procedure to set the display equivalent for a 20 mA input signal, considering span limits.
Explains full trim as a two-point calibration with HART communicator steps.
Details zero trim for mounting effects, with HART communicator or button instructions.
Steps to rerange transmitter using physical zero and span buttons.
Procedure for trimming transmitter's 4-20 mA output using a current meter.
Lists manufacturing locations for the Rosemount 1151 transmitter.
Details ATEX, PED, and EMC directive compliance for European markets.
Covers FM approvals for explosion-proof and intrinsically safe installations in North America.
Details CSA certifications for explosion-proof and intrinsically safe applications in Canada.
Further details on European ATEX flameproof and intrinsic safety certifications.
Information on ATEX Type N and dust certification, including special conditions.
Covers Australian SAA flameproof and intrinsic safety certifications with special conditions.
Special conditions for safe use related to ATEX Type N applications.
Explains how combination certifications are labeled and managed.
Formal declaration by Rosemount Inc. regarding product conformity to European Community Directives.
Lists EN 61326 standard for EMC Directive compliance.
Details PED compliance for specific transmitter models and attachments.
Provides certificate numbers and standards for ATEX compliance.
Lists the notified body responsible for PED compliance in Norway.
Lists ATEX notified bodies in UK and Italy for type examination and quality assurance.
