Do you have a question about the Emerson SW46 and is the answer not in the manual?
Set fan to high speed pull chain, then use speed control for 4 speeds or OFF.
Always set fan switch to HIGH speed before using the wall control.
Shorten fan pull chain 1" below switch body to avoid accidental use.
Covers warranty period, what Emerson will do, how to get service, and exclusions.
Instructions to avoid fire, shock, and personal injury during operation and installation.
Use control only with Emerson ceiling fans to prevent damage or injury.
Designed for one ceiling fan; rated for 1.2 amps at 120 volts.
Set fan pull chain to high speed for optimal performance and to avoid damage.
Ensure power is off, fan is at highest speed, and disconnect power before starting.
Connect wires using provided connectors and secure control and faceplate.
Adjust built-in variable speed devices only when Quietslide is OFF.
Set fan to high speed pull chain, then use speed control for 4 speeds or OFF.
Always set fan switch to HIGH speed before using the wall control.
Shorten fan pull chain 1" below switch body to avoid accidental use.
Covers warranty period, what Emerson will do, how to get service, and exclusions.
Instructions to avoid fire, shock, and personal injury during operation and installation.
Use control only with Emerson ceiling fans to prevent damage or injury.
Designed for one ceiling fan; rated for 1.2 amps at 120 volts.
Set fan pull chain to high speed for optimal performance and to avoid damage.
Ensure power is off, fan is at highest speed, and disconnect power before starting.
Connect wires using provided connectors and secure control and faceplate.
Adjust built-in variable speed devices only when Quietslide is OFF.
The device described in the manual is the Emerson SW46 Quietslide Fan Control.
The Emerson SW46 Quietslide Fan Control is a single-pole, 4-speed fan motor control designed to operate one Emerson ceiling fan. Its primary function is to allow users to select from four distinct fan speeds (1, 2, 3, 4) and an OFF position (0) by sliding a bar on the control. This control effectively converts any Emerson ceiling fan into a four-speed fan. It is crucial that the ceiling fan's pull chain switch is set to its HIGH speed setting before using this wall control to ensure proper operation and to avoid erratic speeds or potential damage to the ceiling fan. The control is specifically designed for fan operation and is not intended for use with accessory light kits.
| Brand | Emerson |
|---|---|
| Model | SW46 |
| Category | Control Unit |
| Language | English |












Loading...