Emerson unidrive m200 - Page 29

Unidrive M200-201 Quick Start Guide 29
Issue Number: 6
* With Unidrive M201, the default is Pad (5).
** If this parameter is read via serial communications, it will show pole pairs.
00.067
Sensorless Mode
Filter
4 (0), 5 (1), 6
(2), 8 (3), 12 (4),
20 (5) ms
4 (0) ms RW Txt US
00.069 Spin Start Boost 0.0 to 10.0 1.0 RW Num US
00.076
Action on Trip
Detection
0 to 31 0 RW Num ND NC PT US
00.077
Maximum Heavy
Duty Current Rating
0.00 to 9999.99 A RO Num ND NC PT
00.078 Software Version 0 to 999999 RO Num ND NC PT
00.079 User Drive Mode OPEn.LP (1), RFC-A (2) OPEn.LP (1)
RFC-A (2)
RW Txt ND NC PT US
RW
Read /
Write
RO
Read
only
Num
Number
parameter
Bit
Bit
parameter
Txt Text string Bin
Binary
parameter
FI Filtered
ND
No
default
value
NC
Not
copied
PT
Protected
parameter
RA
Rating
dependent
US User save PS
Power-down
save
DE Destination
Parameter
Range
(Ú) Default (Ö)
Type
OL RFC-A OL RFC-A
Unidrive M200 201 Quick Start Guide English Iss6.book Page 29 Thursday, September 10, 2015 1:48 PM