1. Turn on the device (e.g. TV, DVD...) you would like to operate. If it is a VCR, Please,
insert a tape, In the code list, please find the brand name and code no of your device
brand (e.g. Lifetec 003, 010, 062), then you press device key to select your desired
operation device (e.g. DVD)
2. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
3. Press the or keys to select “Code Setup” on LCD menu, then press OK
key, Press the or keys to select “Dev Setup” on LCD menu, enter code by
the digit keys, confirm then by OK key.
4. LCD shows “Success!” and exit to the normal mode.
5. Check the function of the keys (e.g. POWER CH+ CH- VOL+ VOL/MUTE). If none of
the keys of your new remote control can work, or most of the keys work improperly,
please try another code, until all basic functions operate properly.
LEARNING
The feature is used to supplement the preprogrammed code list.
1. Press device key to select the device (e.g. DVD) to learn.
2. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
3. Press the or keys to select “LEARNING”, on LCD menu, then press OK
key, then “Learn Key”, confirm by OK key. The “Select key” is displayed on the LCD
screen, press the target key, (e.g. Power).
4. LCD shows “Waiting”, point the transmitter of the original remote control remotes
face to the receiver window of this universal remote control by approximately 50mm
apart. Press the original remote key (e.g. Power) and wait till the LCD displays
“Success!”. Confirm by OK key, and exit to the normal mode by pressing the device
key.
5. Check the function of the key - see if the device reacts, if not, try to run learning
again.
DELETE THE LEARNT KEY
If you like to delete a learnt command, you can follow the steps as below:
To Next Page
Loading...