2. Press the or keys to select “CONFIGURE” on LCD menu, confirm by OK
key.
3. Press the or keys to select “DEV Lock” on LCD menu, confirm by OK
key.
4. Press DEVICE key to select the device (e.g. TV).
5. Press the or key to change to the ON or OFF mode, confirm by OK key.
6. LCD shows “Success!”, this finishes the set-up.
LCD BACKLIGHT
If the background light is on, the background light will be lighted up when you press any
key.
1. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
2. Press the or keys to select “CONFIGURE” on LCD menu, confirm by
OK key.
3. Press the or keys to select “Light” on LCD menu, confirm by OK key.
4. Press the or key to change to the “On” or “Off” mode and then press OK key.
5. LCD shows “Success!”, this finishes the set-up.
CONTRAST ADJUST OF THE LCD
1. Press and hold the SET key on your remote control for more than 3 seconds, then
release it.
2. Press the or keys to select “CONFIGURE” on LCD menu, confirm by OK
key.
3. Press the or keys to select “Contrast” on LCD menu, confirm by OK key.
4. Press the or key to select the contrast level and then press OK key.
5. LCD shows “Success!”, this finishes the set-up.
SHOW FUNCTION
1. Press device key to select the device (e.g. DVD) to show.
2. Press and hold the SHOW key on your remote control for more than 1 second, then
release it, Device key starts to flicker, show starts.
3. Press any key to exit show mode.
ALL ON / OFF
You can turn on / off all devices by one button only.
Press and hold the ALL OFF key for about 1 second and then release it. The remote
control will send out current power signals to turn on (or turn off) each device one by
one. Meanwhile the device key flashes to tell you which power signal is been sending.
CLEAR ALL
Erase all the setting up data, and go back to the factory default settings.
To Next Page
Loading...