8. You will notice that the repeater will automatically fill in the default SSID name
from repeater in to SSID field. It is not necessarily needed but we suggest to
rename the SSID name to: SSID name + AP so you will always know that you are
connected as Access Point.
9. You also have the option to secure the Wi-Fi network by adding an encryption key.
Click in the “Encrypted” field to change the security. Now enter an encryption key
in the “Wi-Fi Key” field.
10. Click “Save” to confirm. The repeater will reboot and make the changes. This will
take approximately 1 minute.
11. Remove the repeater from the power.
12. Install your Ethernet cable from modem/router or router into the “LAN” port of the
repeater.
13. Connect the EM4594 back to the wall outlet.
14. Wait until the “signal indicator” lights up the blue led. This will take approximately 1
minute.
15. You can now make wireless connection with new made SSID as Access Point.
To Next Page
Loading...
