LED indicator :
- When the detector is in normal operating mode, the LED will flash once per
20 seconds.
- The LED indicator starts flashes during test.
3.0 Settings
3.1 First use
Install the battery in the compartment. Please be sure to remover the plastic
protection foil from the battery to avoid connection problems.
3.2 Test Mode
Press the test button for 3 seconds. The LED indicator will start flashing rapidly
and the siren will beep 3 times. After this test is successfully, the detector will
return to normal operating mode.
3.3 Group settings (jumpers)
Note : The jumpers of the group-settings are located inside the smoke detector. By
default these are set to the recommended 24-hour-group.
Every sensor can be configured to be added to a single group by setting the jumper
settings; home-group, normal group, single group or 24-hours group.
Bellow you will see an overview of the meaning and how to configure the jumper
settings for that type of group.
Remark : Determine before pairing with the alarm system in which group the sensor
will be operational. Once the sensor is successfully paired with the system, the group
cannot be changed after pairing!
Remark: If the group of a sensor needs to be changed all sensors need to be paired
with the alarm system once again. It is not possible to remove one single sensor from
a group ! (See chapter “Delete all wireless sensors by text message”)
To Next Page
Loading...