• Push the axle shaft into the brake.
• Lock the shaft with the grey lock that sits on the brake bar. The
shaft shall click in locked position.
• Check that the rear wheel is attached to the chassis properly by
pulling the wheel. Repeat on both sides
WARNING
• Check that the wheel is rmly xed and can not be pulled from
the chassis.
• Avoid driving over sharp objects or sufaces eg. glass or the tyre
can be punctured.
• To achieve optimum handling and to avoid punctures, air
pressure should be correct. Please check the air pressure at
regular intervals (see marking on the tyre).
ASSEMBLY OF THE FRONT WHEELS
• Press in the button on the front section of the pram and push in
the front wheel
• Release the button and check that the front wheel is attached to
the chassis properly by pulling the wheel. Repeat on both sides.
• This is how the chassis should look when fully assembled. (as
illustrated in the picture).
FOLDING THE CHASSIS
• Take off the carrycot or the seat unit.
• Turn the chassis so that the front wheels are pointing forward
(as illustrated in the picture).
• Make sure that the shopping basket is empty before folding the
chassis.
WARNING
• There must not be a child in the pram when it is folded or
unfolded.
• Avoid having children in the vicinity when the pram is
folded or unfolded.
• Ensure that children are kept away from all moving parts
of the pram to avoid risk of injury.
.
Assembly and use of the chassis
To Next Page
Loading...
