EasyManua.ls Logo

Emmaljunga Scooter 2.0 - Care and maintenance: Cleaning and reassembly; Washing instructions; Reassembly after washing

Emmaljunga Scooter 2.0
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
Manual Scooter 2.0 / Scooter S v. 2.2
Care and maintenance
Washing instructions
Hood:
Take off and extend the hood. Spray the hood with lukewarm water. Use a mild liquid soap. Cleanse
thoroughly. Drip dry the hood, fully extended.
• Fabricand5-pointharness:
Remove the fabric from the chassis. Hand wash fabric in lukewarm water. Use a mild liquid soap. Cleanse
thoroughly. Drip dry the fabric. Only wipe the 5-point nylon harness and plastic parts clean with a damp
cloth. Do not hand wash. Make sure the harness is dry before retting.
• Frontbarandfrontbarprotectioncover:
Remove the cover from the front bar. Hand wash in lukewarm water. Use mild liquid soap on the exterior
surface of the front bar fabric. Handle non-woven interior material with care. Drip-dry.
General Information
Ironing: If any fabric part needs to be ironed, always use a 100 % cotton cloth in between the iron and the
fabric to protect the fabric surface. Iron the exterior fabrics (100 %) polyester and the interior fabrics on a
gentle heat (110°C on the iron).
Make sure all parts are completely dry before reassembly. Check the trimmings and the seam on the un-
derside of the seat-fabric and on the backrest pocket.
You may apply a material protector (like Scotchgard™) on the exterior fabric after washing. Always apply
before reassembly.
WARNING
Do not place child/children in stroller for at least 24 hours after applying a material protector.
Reassembly after washing
WARNING
Make sure all parts are reassembled correctly according to the instructions in this manual.
Make sure the seat-board and the footrest-board are correctly positioned before reassembly and use.

Related product manuals