Adjusting Brakes (Front and Back)
Loosen the screw identified on the picture above (white arrow) and pull the wire to the right in order to tighten the
brakes. Pull the wire to the left to loosen the brakes. Tighten the screw after finishing the adjustments.
The brake pads can also be adjusted. Turning the screw, identified with gray arrows on the picture, clockwise will
cause the screw to move inwards, making the pads move outwards. Similarly, turning the screw counter clockwise will
cause the screw to move outwards, making the pads move inwards.
Note: Both pads function together; adjusting only one brake pad may not have any impact on braking system.
Be sure to adjust both brake pads when working with this adjustment.
To Next Page
Loading...
