49
2. Adjusting the Seat Height
• Unlock the seat clamp, loosen the tension adjusting nut.
• Adjust the seat height to your preferred position and lock the clamp.
• Align the clamp opening with the notch in the seat tube and close the clamp lever fully.
• Closing the clamp should require enough pressure that it leaves an imprint in your hand.
WARNING:
There is a MINIMUM INSERT marker on the seat post. You must not raise the seat to a higher pos-
ition than that. Raising the seat post higher will result in injury or damage to property/e-bike.
!
Operation Guide
TENSION
ADJUSTING
NUT
OPEN
CLOSED
M
IN
IN
SE
R
T
MINIMUM
INSERTION
To Next Page
Loading...
