6
Displaying Data from Multiple Sensors, Automatic Cycling through Values from Connected
Sensors
Press the CH button repeatedly to display data from all connected sensors one by one.
You can also activate cycling through data from all connected sensors:
1. Turning on cycle mode
Repeatedly press the CH button until the display shows icon
.
Data from all connected sensors will be shown automatically and repeatedly one after another.
2. Turning o cycle mode
Repeatedly press the CH button until icon
disappears.
Radio Controlled Clock (DCF77)
After registering with the wireless sensor, the weather station will automatically begin searching
for DCF77 signal (hereinafter referred to as DCF) for 7 minutes; the icon will be ashing. No other
data on the display will be updated while the search is in progress and all buttons will be disabled
(except for SNOOZE•LIGHT). Once signal is detected, the icon will stop ashing and the current time
will be displayed along with the
DCF icon. If no signal is detected, the DCF icon will not be shown.
To repeat the search for DCF signal, hold buttons MEM and HISTORY simultaneously. To cancel
the search, again hold buttons MEM and HISTORY simultaneously. DCF signal will be synchronised
daily between 2:00 and 3:00 am.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must always set the correct time zone for the country where you are using the
station, see Manual Settings.
In standard conditions (at safe distance from sources of interference, such as TV sets, computer
monitors), the reception of time signal takes several minutes. If the weather station does not detect
the signal, follow these steps:
1. Move the weather station to another location and try to detect DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television
sets). It should be at least 1.5 to 2 m during the reception of the signal.
3. When receiving DCF signal, do not place the weather station in the proximity of metal doors, win-
dow frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).
4. In reinforced concrete structures (cellars, high-rise buildings etc.), the DCF signal reception is
weaker, depending on the conditions. In extreme cases, place the weather station close to a
window toward the transmitter.
Reception of the DCF 77 radio signal is aected by the following factors:
• thick walls and insulation, basements and cellars
• inadequate local geographical conditions (these are dicult to assess in advance)
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.
Manual Settings
1. Long press the MODE button.
2. Then, repeatedly press the MODE button to choose settings for: 12/24 time format – time zone
– date format – year – month – day – hour – minute – calendar language – bar. pressure unit
(hPa, InHg) – °C/°F temperature units.
You can move between the values by pressing the MODE button, set values using buttons MEM
and HISTORY.
Calendar languages are as follows:
EN – English; GE – German; DA – Danish; SP – Spanish; DU – Dutch; FR – French; IT – Italian
Setting Altitude
To achieve more accurate calculation of pressure values, it is advised to manually set the altitude
for the place where the weather station is being used.
1. Hold the SNOOZE•LIGHT button until the altitude value starts ashing.
2. Set the desired altitude by pressing MEM or HISTORY. The settings range between -190m
to 2,000 m, with 10 m increments.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
