8
As the weather forecast may not be 100 % accurate, neither the manufacturer nor the seller can be
held responsible for any loss caused by an incorrect forecast.
When you rst set or reset the weather station, it takes about 12 hours before the weather station
begins forecasting correctly.
Weather Forecast Icons:
sunny cloudy overcast rain heavy rain
– the snowake icon appears at outdoor temperature between -3 °C to +1 °C.
Nice Environment Icon – Smiley
Nice environment icon is displayed in eld no. 30.
If the humidity is between 40–70 % RH and the temperature between 20–28 °C, the screen will show
the COMFORT icon – nice environment.
If the humidity is lower than 40 % RH, the screen will show the DRY icon – dry environment.
If the humidity is higher than 70 % RH, the screen will show the WET icon
– wet environment
If temperature is not between 20–28 °C and humidity is not between 40–70 % RH, no icon will be
displayed.
Setting Temperature Limits for Maximum and Minimum Temperature
Temperature limits can be set independently for up to 3 outdoor temperature sensors.
Long press the ALERT(C) button. The value for setting maximum temperature alert will begin ashing
Use the
MEM and HISTORY buttons to set the desired temperature between -49 °C and 70 °C.
Then press the ALERT(C) button and set the minimum temperature for the alert between -50 °C
and 69 °C .
Press the ALERT button to activate/deactivate the temperature alert function. The
icon will appear
in eld no. 26.
Holding the adjustment buttons will make the values change faster.
Temperature limit range is -50 °C to +70 °C, increment 1 °C.
When the set temperature limit is exceeded, an audio alarm will sound repeatedly and the value
will begin ashing.
Pressing the ALERT button silences the audio signal.
Battery Replacement Warning
Replace the batteries in the station or the sensor once the display of the station or the sensor shows
the low battery icon
.
Station Display Backlight
When powered via adapter
Permanent backlighting is set automatically.
Repeatedly pressing the SNOOZE•LIGHT button will allow you to set 3 dierent modes for permanent
backlighting (o, medium backlight level, maximum backlight level.)
When powered by 3× 1.5 V AAA batteries
Display backlighting is o. Pressing the SNOOZE•LIGHT button will turn the display backlight on for 10
seconds, then it turns o again. When the station is only powered by batteries, permanent backlighting
of the display cannot be activated!
Note: The inserted batteries serve as backup for the measured/set data.
If batteries are not inserted and you unplug the adapter, all data will be erased.
Care and Maintenance
The product is designed to provide trouble-free service for many years if used appropriately. Here
are some tips for proper operation:
• Read the manual carefully before using this product.