Emos E5059 - Manual Operation and Settings; Time, Date, and Location Configuration; Alarm and Snooze Functionality

28
b) Temp Alert – Temperature Alert Settings (see Fig. 5-11)
1. Tap Temp Alert.
2. Set the indoor temperature (Indoor) and outdoor temperature (Outdoor).
3. Activate by tapping the slider on the top right and press Conrm.
c) Graph Curve – Graph of the History of Temperature/Humidity/Pressure/Wind/Rainfall
(seeFig. 5-12)
1. Tap Graph Curve.
2. Select the icon on the top left and select the type of measurement.
3. Select the time period for measurement: day, week, month.
4. Tap the arrow on the top right and enter your e-mail. Tap Conrm.
5. A link to an xlsx le will be sent to your e-mail; the link is valid for 24 hours.
d) Unit conversion – Selection of Temperature/Pressure/Wind/Rainfall Units (see Fig. 5-13)
1. Tap Unit Conversion; to change the unit, tap the arrows on the right.
2. Tap Conrm.
If you wish to delete a station from the application, tap the My Home icon, long-press the name of
the station and conrm by pressing Remove Device (see Fig. 5-14).
Manual Setting of Time, Date, Location for Displaying Sunrise and Sunset Time
1. Press and hold the MODE button.
2. Set the following values using the + and – buttons:
• 12/24 h time format, time zone, date format, year, month, day, hour, minute, calendar
language (ENG), city abbreviation.
• For the Czech Republic, use PRG (Prague). Other cities and countries are listed on page 8.
3. Conrm the selected value by pressing MODE, hold + or – to navigate faster.
Setting an Alarm
The weather station allows setting 2 alarms.
Select the alarm of choice:
1. Press the MODE button 1× to view settings for alarm no. 1 (A1).
Press the MODE button 2× to view settings for alarm no. 2 (A2).
2. Long-press the MODE button – the time settings will start ashing.
3. Set the hour and minutes for the alarm by pressing + or –.
Conrm the selected value by pressing MODE; holding the + or – buttons speed up value change.
Alarm Activation/Deactivation
Select the alarm of choice:
1. Press the MODE button 1× to view settings for alarm no. 1 (A1).
Press the MODE button 2× to view settings for alarm no. 2 (A2).
2. Press + or –; the or icon will appear on the screen – the alarm is now activated and
will ring at the set time.
3. If you press + or – again, the alarm icon will disappear and the alarm is deactivated.
Snooze Function
Alarm ringing can be postponed by 5 minutes using the LIGHT/SNOOZE button located on the top of
the weather station. Press the button when the alarm starts ringing. The alarm icon will start ashing.
To cancel SNOOZE mode, press any other button – the alarm icon will stop ashing and will remain
on the screen. The alarm will be re-activated the next day.
Setting Altitude and Atmospheric Pressure
The station shows atmospheric pressure in hPa/inHg/mmHg and keeps a history of pressure readings
in the last 72 hours.
To achieve more accurate calculation of pressure values, it is advised to manually set the altitude
for the place where the weather station is being used.
1. Long-press the LIGHT/SNOOZE button.
2. The altitude icon will start ashing. Adjust the value using the + and – buttons. Minimum and
maximum altitude settings are -200 m to +2000 m respectively (10 m resolution).