2
THERMOSTATIC RADIATOR VALVE T30
Technical specication:
Temperature range: 5 to 30 °C (tolerance 0.5 °C)
Displayed temperature range: 0 – 30 °C (tolerance 0.1 °C)
Power: 2× 1.5 V AA (is included)
Maximum current consumption: 100 mA
Valve’s stroke : max. 4.2 mm
Regulatory power: 80 N
Valve’s installation dimension: M30 × 1.5
Operating temperature: 5 °C – 55 °C, humidity <90 %.
Installation
1. The radiator valve T30 is intended to be used for all kinds of commercially available radiator valves without
the need of interrupting the heat circulation. In case the thermostatic radiator valve is not compatible, please
follow the instructions stated in the paragraph called: Compatibility.
2. Before the installation insert the batteries into the radiator valve. Remove the old radiator thermostat valve
by loosening the nut placed on the radiators valve. Place the T30 on the front part of the valve and manually
tighten the nut.
Note:
• The T30 valve’s lifter must be connected in the center with the lifter on the valve.
• The T30 valve must not be squeezed or wedged.
• When installing the T30, make sure the display is well readable.
Compatibility
Some radiator valves my not be compatible with the T30.
Please, compare your valve with the producer’s information and install the suitable reduction – if necessary.
Compatible appliances:
• Heimeier
• Junkers
• Landy + Gyr
• MNG
• Honeywell Braukmann
Enclosed reductions for appliances:
• Danfoss RA, RAV, RAVL
GB
To Next Page
Loading...