Emos P5630 - Advanced Settings - Valve Operation and Compensation; Temperature Limit Settings for Open Window; Valve Stroke, Compensation, and Display Settings

7
• By the thumb-wheel select DEC , conrm by pressing OK.
• By the thumb-wheel set the temperature in the range of 0.2 °C to 3 °C (tolerance 0.1 °C), conrm by pressing OK.
• In case the room temperature decreases about the preset value, the Open Window function will be activated.
• The Temperature Limit for Deactivating the OPEN WINDOW Function
• Press and hold the PROG button.
• By the thumb-wheel select INC , conrm by pressing OK.
• By the thumb-wheel set the temperature in the range of 0.2 °C to 3 °C (tolerance 0.1 °C), conrm by pressing OK.
• In case the room temperature increases about the preset value earlier than is preset, (TIME ), the Open
Window function will be deactivated.
Surrounding temperature compensation
The temperature sensor which detects the surrounding temperature is located in the valve’s body which is mounted
on the radiator.
The measured temperature therefore may be higher than the temperature in other parts of the room.
To correct the temperature press and hold the PROG button and by the thumb-wheel select TOE, conrm by pressing OK.
By the thumb-wheel set the temperature correction in the range from –3 °C to +3 °C, tolerance 0.5 °C.
The valve stroke setting
The thermostatic valve operates in the factory settings with the optimal valve stroke setting (standard stroke mode)
that is necessary for the room temperature regulation. In case the full valve stroke should be used or the valve does
not completely closes, access the full stroke mode.
• Press and hold the PROG button and by the thumb-wheel set TAP, conrm by pressing OK.
• By the thumb-wheel, set:
• ON - the valve will be in the full stroke mode
• (This mode may lower the batteries lifetime)
• OFF – the valve will be in the standard stroke mode
• Conrm by pressing OK, to exit menu press the FUN button.
Current room temperature display
• Press and hold the PROG button, by the thumb-wheel set ROOM, conrm by pressing OK.
• By the thumb-wheel, set:
• ON – the current room temperature will be shown with the icon
.
• OFF – the current room temperature will not be shown
• Conrm by pressing OK, to exit menu press the FUN button.
Daylight saving time (DST)
• Press and hold the PROG button, by the thumb-wheel set DST, conrm by pressing OK.
• By the thumb-wheel, set:
• ON – DST will be activated
• OFF – DST will be activate
• Conrm by pressing OK, to exit menu press the FUN button.
Reset
• Press and hold the PROG button, by the thumb-wheel set RESET, conrm by pressing OK.
• YES – factory setting, all the input values will be deleted
• NO – return to menu
• Conrm by pressing OK, to exit menu press the FUN button.