Emos P5801 - Page 9

8
9
Note:
If dual tari is set, tari 1 will start from the set time and turn o when the set time for tari
2 comes. Current tari 2 will end the moment tari 1 begins.
3. Overload settings
Hold the „ENERGY/+“ button for 3 seconds; the top left corner of the screen will
now display „OVERLOAD“. Then, using the „HISTORY“ button, move between values
and set the maximum load. The default setting is 3 680 W. You can save the settings
by pressing „SET/OK“. After exceeding the set value, the „OVERLOAD“ sign will start
blinking.
4. Setting CO
2
:
Keep pressing „COST/-“ until you reach the following screen.
Then hold the „SET/OK“ button for 3 seconds. Using the „HISTORY“ button, move
between values. „ENERGY/+“ and „COST/-“ increase/decrease the values. You can
save the settings by pressing „SET/OK“.
5. Consumption graph for the last 7 days/weeks/months
Using the „HISTORY“ button, you can change display settings to the last 7 days,
7 weeks or7months.
P5801